Volkswagen Golf/GTI/Rabbit

Categories

iABED Billet Aluminum Rear Main Seal Upgrade

Go Back
iABED Billet Aluminum Rear Main Seal Upgrade iABED Billet Aluminum Rear Main Seal Upgrade

Product Information

Do you own a 2.0T TSI powered VW or Audi? Do you have a engine stumble or misfire, check engine light or mysterious oil leaks in the driveway? There's a good chance your rear main seal and PCV valve are failing. Don’t replace it with another part from the dealer that is known to fail. iABED Industries has developed an upgraded solution to permanently fix your rear main seal. The most common cause of rear main seal failure is a faulty PCV valve. The TSI engine is known to have PCV valve failures, which will cause an excess of crankcase pressure. This is more pressure than the rear main seal can handle. PCV issues can surface with multiple symptoms or virtually none at all.

The factory stamped unit uses a flimsy and very thin rubber surface to seal around the crankshaft. The crank is constantly spinning inside this seal too so over time as heat cycles are put through the engine, the rubber will expand and contract and become brittle, especially when it is constantly saturated with oil. iABED's replacement solution uses a patented billet machined plate that is bored to a larger diameter so that a Viton rubber seal can be used. The Viton seal is more heat resistance, fluid resistant, and more than twice as thick.

Brand: iABED Industries
Product Code: 462-103-171F
$119.00 $99.00
Add to Cart